When a TV master is uploaded to a broadcaster, each video part's in/out timecodes are specified in the upload templates. This information is used to cut the VoD file for OTT platforms automatically.
The timecodes for all asset parts are listed under the "VideoPart" - tab to verify the information uploaded. The Mediabank coordinator does the verification.
To modify or add video parts, you must have administrative rights.
"Video parts" is available from the metamodule as a component (Tab) in:
- Library
- Review & Approval
- Compliance
A typical Video Parts setup for Broadcast delivery
End of media: Are calculated from the time codes from Part 1 to Part #.
Part 1: Timecode always starts with 30 sec delay
The total duration of parts HH:MM:SS:FF is the calculated time excluding all pre/post frames.
You usually end your media parts with the last frame 24 (FF). If the Media delivery contains more than one part, fill in the media start details and the total end, including all video parts. Then, click +Add another for each additional Media part.
-------------------------------
End of article